1 and 2 Australian/New Zealand Standard Gas installations Part 1: General installations Superseding AS/NZS 5601.1:2010.
Gas Installations This is a free 10 page sample.AS/NZS 5601.1:2013 Australian/New Zealand Standard.GAS INSTALLATIONS Australian Standard.This Standard is referenced in Legislation. AS/NZS 5601 Set:2013 Gas installations Set This publication is available in our OnTheGo format.Australian Electrical and Electronic Manufacturers. This Joint Australian/New Zealand Standard was prepared by Joint Technical.Australian Standard for General Installations-Part. Gas Installation Australian Standard for General. Australian Standard for Gas Installations.AS 5601 means Australian Standard, 'Gas Installations' Autogas means liquefied petroleum gas which is.Gas Standards (Gasfitting and Consumer Gas.Gas Standards (Gasfitting and Consumer Gas Installations) Regulations 1999: : Current: 05-c0-01. Australian/New Zealand standards AS/NZS 5601.1 and. Latest gas installation standards published AS/NZS 5601.1.Standards Australia is currently developing a new website.REMINDER AS NZS5601 2013 gasinstallations must now comply with Australian Standard.You must submit a safety and operating plan for each facility. You are required to comply with this standard if you operate a gas facility.AS/NZS 5601.1:2010 This Joint Australian/New Zealand Standard was prepared by Joint Technical. Regulation 2012 and Australian Standard AS 5601-2004. AS 5601-2004 Gas installations (FOREIGN STANDARD) Specifies requirements for consumer piping, flueing, ventilation and appliance installations which.The means of compliance in sections 3 to 6 are not the only means of compliance with the performance criteria of section 2. Sections 3 to 6 provide more detailed information as a means of compliance with the performance criteria. It includes performance criteria for compliance with legislative requirements for the safety of gas installations. Section 2 covers the various aspects of a gas installation that contribute to its safety. Gas Installations, to supersede AS/NZS 5601.2:2010. It is intended that only the performance requirements of section 2 (performance- based design and other essential requirements) will be mandatory in New Zealand.Īustralian New Zealand Standard AS / NZS 5601 Gas. Plumbers, Gasfitters, and Drainlayers Act 2.
The standard does not apply to: portable or mobile gas appliances (such as barbecues or patio heaters) that are connected directly, or by hose assembly, to an LP Gas cylinderautomotive CNG compressors and refuelling stationsinstallations in vehicles for automotive usecaravans and boats (covered in AS/NZS 5. For New Zealand, these requirements cover gas installations downstream of the point of supply (as defined in the Gas (Safety and Measurement) Regulations 2. Part 2 provides a stand- alone standard for LP Gas installations in caravans and boats for non- propulsive purposes. 0 standards will not be withdrawn until the Regulations are amended. Regulations are amended, which is likely to be in 2. Gas (Safety and Measurement) Regulations 2.
Gas installations – Part 2: LP Gas installations in caravans and boats for non- propulsive purposes replace the 2. Gas installations – Part 1 General installations and AS/NZS 5. 2 were revised by the joint committee AG- 0. The joint Australian/New Zealand standards AS/NZS 5. Latest gas installation standards published AS/NZS 5. 1) Australian/New Zealand Standard Thread: copy of Australian standard gas installation As 5601-2004. OJ STANDARDS NEW ZEALAND PAEREWA AOTEAROA STANDARDS Australia f AS/NZS 5601.1 :201 0 (Incorporating Amendment No. In Queensland, the current Australian Standard for gas fitting in domestic, commercial and. 1) Australian/New Zealand Standard AS/NZS5601.1:2013 Gas installations Part 1: General installations. AS/NZS 5601.2:2010 (Incorporating Amendment No.
The storage and handling of LP Gas” is the primary standard. The standards are joint Australian and New.
General Gas Installations AS/NZS 5601.2:2013.